An exciting rumor is that there may be a hardcore Challenger ACR, in 2021, to replace the discontinued American Club Racer Viper. Even though the Challenger ACR has already been presented, in 2011, at the SEMA Show with SRT8 goodies as a one-off concept, Dodge has failed to come up with a production model. Insider “Muther” told Allpar.com that we should look forward to two variants, one with the Hellcat Redeye engine and the other with the 392 HEMI. He stated, “The supercharger is not...
The Dodge Scat Pack was originally introduced in 1968 with the Charger R/T, Coronet R/T, Dart GTS, and Super Bee. In 1969, the Charger Daytona joined the Pack. In order for a car to enter the Scat Pack it had to be capable of running the quarter mile in the 14s (14.99 sec. or faster). Mainly a marketing term, Scat Pack cars got twin bumblebee stripes and special decals. It became legendary in the enthusiast community and symbolized one of the most feared groups of street machines every to...
Dodge was founded in 1900 by Horace and John Dodge (The Dodge Brothers). It was initially known as the Dodge Brothers Company and used to sell bicycles, but then within two years it became a major supplier of axles, engines, and transmissions to the automobile industry. The company started by producing chassis and engines for the Ford Motor Company and Olds Motor Vehicle Company. However, with the stress and demands of the booming automobile industry, the brothers decided to tinker with the...
There has been much discussion if an oil catch can is necessary on a high performance engine. It is my opinion that the relatively modest price (usually about $100) is cheap insurance for your engine. First, let's go over what is currently happening in your engine without a catch can installed. All internal combustion engines that run off gasoline are 4-stroke engines. This means that the piston has to go up and down a total of 4 times to complete a cycle. The piston first goes down with...
The planning and design of the Challenger concept car started in 2004. At that time, Chrysler’s Pacifica Studo was given the assignment to work with the exiting LX platform (i.e., Charger, Chrysler 300 and Magnum) to develop a 2-door, rear-wheel drive concept car. Many of the designers were musclecar guys and a new Challenger was proposed to be built around the 6.1 Hemi engine. There was a lot of conversation as to how much retro design features should be built into the car. Based on a...
Crumple zones, crush zones, or crash zones, are a structural safety feature used in automobiles, to absorb the kinetic energy from the impact during a collision by controlled deformation. This energy is much greater than is commonly realized. A 4,409 lb. car traveling at 37 mph.,before crashing into a thick concrete wall, is subject to the same impact force as a front-down drop from a height of 47 ft. crashing on to a solid concrete surface. Increasing that speed by 50% to 56 mph. compares...
The Trans-Am Series was created in 1966 by the Sports Club of America (SCCA). Originally known as the Trans-American Sedan Championship, the name was changed to the Trans-American Championship for 1967. The series has in fact gone by a variety of different names through the years (too many to list), some linked to sponsors, some not. It has evolved over time from its original format as a Manufacturers' Championship series for modified passenger sedans and coupes to its current form as a...
There are three different terms that are used concerning a car's weight- Gross Vehicle Weight Rating (GVWR), Gross Vehicle Weight (GVW) and Curb Weight. So how are they different? A car’s Gross Vehicle Weight Rating (GVWR) refers to the maximum poundage your car can weigh to operate safely and without harm to its components. Put simply, it's the maximum weight before everything breaks. Manufacturers calculate this number by testing the structural integrity of your car’s suspension...
Hood pins are used as a secondary restraint for the hood and are attached by a pin and plate drilled through the hood. They were originally made for the racetrack to keep hoods buttoned down at high speeds, but found their way onto muscle cars of the late 60s/early 70s. Hood pins (two per hood) were most prevalent on Dodge and Plymouth muscle cars of that era (e.g., Challengers, ‘Cudas, Road Runners, Daytonas, GTXs, Super Bees, etc.). They were, primarily, a styling element used to give a...
Back in middle school science class, we learned that in order to make fire, you need three ingredients: fuel, ignition and air- or, more specifically, oxygen. You’ll also remember that cold air is denser than hot air, putting more oxygen in the same amount of volume. While the modern internal combustion engine does a fine job of delivering fuel and ignition, that cold air part becomes tricky as you try to route fresh air from outside through a hot engine compartment. In response, in the late...
Racing stripes are usually a “must have” for owners of muscle cars. These stripes, originally called “go faster stripes,” first appeared on Cunningham race cars in 1951. Two parallel blue stripes ran from front to rear in the center of the white car body. Their main purpose was to help spectators identify the cars during races. They evolved from the traditional FIA registered U.S. Racing color of a white body and blue chassis, which dated from when racing cars had the chassis exposed. The...
In the late 60s/early 70s, Dodge was already offering some of the hottest cars of the muscle car era- awesome machines like the Hemi Challenger and 440 Six-Pack Super Bee. Designers, however, decided to rev up the cars’ visuals to match, creating a far-out assortment of vibrant exterior paint colors. These special colors (a $15 option) generated a big buzz in the showrooms and launched an industry trend. The color palettes used by all the automakers were opened up, giving paint designers...
Paddle shifters, once exclusive to race cars and exotic sports cars, like the Ferrari F430, are now becoming commonplace on performance cars with automatic transmissions. This is because manual transmissions are going away faster than the landline telephone. Critics of automatics say that they take the passion and command out of driving. Paddle shifters, however, bring some of that joy and control back by allowing drivers to manually shift an automatic transmission with steering-wheel or...
Since the beginning of hot rodding, enthusiasts have tinkered with their car’s exhaust system, particularly the mufflers, to get the “right sound.” A muffler’s job sounds easy enough- reduce exhaust volume to tolerable levels while allowing the sweet sounds of your ride to waft through the air. But this becomes a monumental task as horsepower increases. Engines build horsepower by pushing spent exhaust out of the tailpipe as fast as possible. As pistons furiously churn, exhaust velocity...
WD-40 is truly a versatile product. It was created in 1953, by three technicians, at the San Diego Rocket Chemical Company who were searching for a rust preventative solvent and degreaser to protect missile parts. Its name comes from the project that was to find a “water displacement” compound. They were successful with the 40th formulation, thus Water Displacement #40, or WD-40 was born. Initially it was purchased, in bulk, by the Corvair Company to protect its Atlas missile parts....