My best so far on the street. [ATTACH] [ATTACH]
[MEDIA] You mean any side street is not good enough? :D
Back to the original topic if you are running the stock OEM intake manifold on a 5.7L or 6.4L, they loosen over time so check the bolts for...
If you are running the OEM 2 piece driveshaft parking on an incline puts a lot of pressure on the center support bearing rubber support gasket and...
I like the air ride suspension, that's pretty cool.
No it looks good like it is.
I like the supercharger, the power is there instantly, on the low end, the mid range, and the top end, it only depends on how far you press the...
They are Magnaflow tips.
No offense intended to anyone but I never liked the Dodge Challenger fender flares, to me they are just too much, and on the front they look...
They are made of some type of black polymer material and are very substantial, they are not plastic they have a natural matte black color finish....
230mm
Well it was what was on my 2015 Challenger R/T 5.7L A8 and I still have it in my storage room.
Most all of these drain and fill plugs torque to 20 ft.lbs. and you do fill until it comes out of the top fill port, that is why there is a top...
Actually I'm getting great traction believe it or not with 275 width tires but they Are the Mickey Thompson ET Street S/S 275/40/20 Treadwear #...
Most everyone that had the aluminum intake manifold did not experience any of the bolts loosening, I would assume that is the same in your case?
I haven't dyno'd it, or taken it to the track, just finished installing it about 3 weeks ago, still learning the difference from naturally...
Many have actually caused these failures by increasing HP past what the parts can actually handle, or gone to the stickiest tires possible to run,...
Yes I did, my Maggie is an older model and it ports directly back into the air horn, the catch can keeps that area before the flapper door free of...
Well the intake manifold bolts are not a problem anymore for my 5.7. [ATTACH]
Our Challengers are factory preset with negative camber, make sure it is as factory aligned as possible to get the best tire wear. If the tires...
Ignorance is Bliss, isn't it. Not all Pirelli tires are the same there are different model lines, and what they put on the Challenger out the...
I joined here to help other Challenger owners, simple as that, I don't know what you joined for!
Our Challengers run a 2 piece driveshaft, the problem with it is the center support has the bearing held in place with a formed rubber gasket....
My concern is that X and H combination is going to increase flow resistance which increases back pressure, that may be good if the engine needs...
@Moparisto I quoted the OPs original post for your reading comprehension skills, as my post falls in line with answering his question regarding...
Separate names with a comma.