How to Remove Front End

Discussion in 'Challenger DIY/Tech Info' started by SRT-Tom, Oct 10, 2012.

Car Parts
  1. Oct 10, 2012 at 11:40 AM #1
    SRT-Tom

    SRT-Tom Well-Known Member Staff Member Super Moderator Article Writer

    Posts:
    8,244
    Likes Received:
    2,796
    Joined:
    Oct 2, 2011
    Location:
    southern New Jersey
    1.Raise and support the vehicle.
    2.Remove the left and right front splash shields as necessary.
    3.Remove the belly pan.
    4.Remove the mounting fasteners that secures the front fascia assembly (9) to the inside of the front fender.
    5.Partially lower the vehicle and remove the push-pin retainers (10) that secure the front fascia assembly to the upper radiator support.
    6.Disconnect the Tire Pressure Monitoring System connector.
    7.Carefully pull the left and front side of the fascia out of the fender mounted fascia mounting brackets.
    8.Carefully pull the front fascia assembly forward to disengage the push-pin retainer from the slot in each side of the fascia and disconnect the fog lamp wire harness connectors, if equipped.
     

    Attached Files:

    Last edited: Oct 10, 2012
  2. Oct 11, 2012 at 1:32 PM #2
    Storm Rider

    Storm Rider Full Access Member

    Age:
    63
    Posts:
    1,294
    Likes Received:
    7
    Joined:
    Sep 18, 2011
    Location:
    High Point, NC
    That sounds like something for the body shop. But 8 steps ain't bad if you are bold enough to try it.